PRO SOS2 Palletisation Gripper Set Up OPAL Bag Solutions Page 1 of 4
PAR-OBSHO-SOP-5070 Status/Version: Current /2.0 Approved Uncontrolled Date: When 12/09/2017 Printed Responsible (OBSHO),Operations Authoriser: Simon Person:Business Neiger Manager Systems Manager 1.
PRO SOS2 Palletisation Gripper Set Up OPAL Bag Solutions PAR-OBSHO-SOP-5070 Uncontrolled When Printed Authoriser: Simon Neiger Page 1 of 4 Status/Version: Current /2.0 Approved Date: 12/09/2017 Responsible Person:Business Systems Manager (OBSHO),Operations Manager 1. PURPOSE Bag positioning for robot gripper 2. SCOPE Changeover of finished bag length for correct bag pick up and placement by robot gripper 3. RESPONSIBILITY Operators 4. APPLICABLE SITES Keon Park SOS2 5. REFERENCES Robot Cage entrance SOP 6. SAFETY REQUIREMENTS Ensure Robot Cage SOP entrance is adhered to 7. ENVIRONMENTAL REQUIREMENTS Nil 8. GMP REQUIREMENTS As per site standards
Step 1:
Enter safety the robot key. cell using key the
access This
must be possession at all
in
times when in the robot cell.
Step
2:
Select the correct bag
template the
for finished
length of bag on the BPO.
Step
3:
Using correct
the template,
place in
holes
studs locating
of plate fit
backing and nuts
so the
that template
secure.
is
Step
4:
Fully the side
extend right
stop
and the
cylinder loosen
clamps adjust cylinder
to the
to the
meet template.
Tighten locks in
the once
correct
position.
Step
5:
Release air
the pressure
from cylinder the
the
lower
on
port.
Step
6:
Extend left
the cylinder
down; the to
loosen clamp
adjust cylinder meet
the
to
the
Tighten
template.
the
clamp in
once correct
position.
the
Step
7:
Remove robot gripper template, is ready for so
production.
